Toilet angle stop valve N10121009 is to improve the water inlet and outlet of the toilet to control the water inlet pressure and close the water inlet function, and to have a spray gun to easily clean the toilet. We also supply angle valve in plumbing, double angle stop valve, angle valve double outlet, right angle stop valve, and offers cp brass angle valve price, brass angle valve price, angle stop valve price, 

Angle valves are required in many places, so we need to know where the installed angle valve is used, whether it is for the toilet or the washbasin. There are many angle valves used in the home, there are direct and flat angle valves, and they are usually installed with anti-slip glue over the turnbuckle, so that it is not easy to leak. We take the toilet as an example to teach you how to install the angle valve.

Usually the water inlet angle valve is installed on the wall 200mm above the ground on the side of the toilet. For this type of high-back toilet, the angle valve is installed on the back of the toilet and is blocked by the toilet after installation. In order to facilitate maintenance, manufacturers generally have maintenance holes in the lower part of the toilet considering these reasons during production. During maintenance, you can enter the internal switch water inlet angle valve from the maintenance hole, or open the water tank cover from the upper part of the water tank for maintenance, or remove the whole set of products for maintenance.

The position of the toilet angle stop valve installation: add a sealing rubber ring between the interface with the screw thread and the angle valve interface, then connect the angle valve to the threaded interface and tighten it. Be careful not to mess up the water inlet and outlet. Put a nut on the upper end of the sewer pipe, and then put an oblique rubber ring on it. The oblique rubber ring mouth is upward. If the stainless steel pipe or plastic pipe is used for the following water pipe, a thick oblique rubber ring should be used. If a one-inch galvanized pipe is used, a thinner Slanted rubber ring. Put the upper end of the sewer pipe into the hole at the lower end of the angle valve, and then make sure to tighten it when connecting.

 The most important thing for the equipment in the toilet is to pay attention to waterproof treatment. Once the ground seeps, it will be a headache, so we should also pay attention to this when using the toilet corner valve. Generally, our toilet corner valves are installed by workers when the toilet is installed. At this time, we must do a waterproof test during the acceptance, otherwise we will find something for ourselves.

1.  check the material of toilet angle stop valve. The best material is brass, which will be heavier, and the excellent material will greatly extend the service life of the product; although the zinc alloy on the market is relatively cheap, it is easy to break after a year of use, and maintenance is difficult.

2. check the valve core of toilet angle stop valve. Generally, ceramic spools are used. The spool is the heart of the product. It depends on it for tightness and service life, especially the sealing ring and ceramic sheet inside. But generally we can't see it, so we have to try the feel. The feel is too heavy, the switch is uncomfortable, the feel is too light, it will leak after a long time, and the soft feel will last longer.

3. check the electroplating gloss of toilet angle stop valve. Pay attention to the gloss, whether the product is blistered or scratched, the surface of a good product is smooth and shiny, and it is smooth and flawless to the touch. In addition, the salt spray test of the toilet angle stop valve on the market can not meet the requirements, not to mention that this is only a kind of thing installed in the toilet, and few people pay attention.